Rago Fabrication

The Aqua Tank - 5th Gen 4Runner Washer Fluid Reservoir Replacement

R1622T4RWB

Holds 2 liters of washer fluid
Uses factory pump and connections
Made from Aerospace Aluminum
Sealed and pressure tested

$ 274.95

This item is in stock and ready to ship!

The Aqua Tank is a full washer fluid reservoir replacement that mounts snugly behind the grille of your 4Runner - Made out of 100% aluminum and tig welded for years of service. This system uses factory pumps and connections that have been sealed and pressure tested for optimum use. This product also features a Billet Aluminum threaded cap, fabricated right here in the USA. The install is extremely simple, and takes about 10 minutes start to finish.

The Aqua Tank was designed to solve a common problem amongst Toyota 4Runner owners. After upgrading your tires and bumper, your plastic factory washer fluid tank is now exposed and prone to damage on the trails - not to mention it doesn't allow for optimum tire clearance when stuffing those big 35-inch tires under the fender.

Fitment is for 2014-2023 5th Gen 4Runner ONLY
Holds 2 liters of washer fluid
Uses factory pump and connections
Made from Aerospace Aluminum
Sealed and pressure tested
Relocates behind grille
Billet Aluminum threaded cap
Allows for additional tire clearance
Replaces plastic factory washer fluid tank

Disclaimer: Not all bumpers and situations are the same. Slight bending of the power steering cooler line might be necessary but not in all cases. Due to different applications some modifications might be necessary to aftermarket add-ons beyond our control.

Features

Uses Factory Pump Connections & Hardware

Allows for improved tire clearance

holds 2L of washer fluid

Sealed & Pressure Tested

The Aqua Tank - C4 4Runner Lo-Pro Winch Bumper

If you have a C4 4Runner Lo-Pro Winch Bumper / 5th Gen, this tank is a perfcet fit and the bumper does not get in the way of the relocation point. The tank has great welds and the fit and finsh is 10/10. Great Product!

Loved it.

Great Fit

Fits perfect. Installed in less than 2 hours

Great product just didn’t work for me

This piece is very very well made. Welds are beautiful. Want so bad for it to work, but with my CBI full width bumper I was unable to make it fit. Someone with some brains would probably be able to fab up a replacement mount for it but unfortunately for me I have little kids that require attention over my 4Runner

Rago Washer Tank Installation on a 2020 Toyota 4Runner

First of all the tank that I received was of a very good quality and well designed for the 4Runner application. We did paint it black so it would ascetically fit in with the vehicle's appearance. The online installation video was very helpful, but was a little more involved on our 2020 4Runner due to all of our original body inner fender, bumper and related trim still being in place. (We are installing the washer relocation tank in preparation to installing a new aftermarket front bumper) Once the new washer tank was bolted in, the factory pumps went in just as the video showed and no leaks.
As far as drilling the hole in the top plastic cover that covers the area between the front grill and the radiator. I used some green painters tape to temporarily attach a roofing nail (sharp pointed end sticking up) to the center of the washer fluid filler cap. I then placed the plastic cover in the proper mounting location. I then used a rubber mallet to lightly tap the area where the tank/roofing nail were located. This make a indent transfer make exactly where the center of the filler cap is located (no guessing). I then used a 3 1/2 inch hole saw to cut the opening for the washer tank filler cap (like the video showed) and then cleaned up/finished the hole with some sand paper. Simple and clean.

1 2 3